Copyright ©

© 2003-2019 GHIT ApS. All rights reserved.

DomainScan Server Monitoring is freeware. The product can be used 'as-is' and distributed freely.

The following technologies are partially used by DomainScan:
   ICS © Overbyte / François Piette
   Jedi VCL © JVCL Team
   Software solutions by Soft Gems /© Mike Lischke
   zlib © Jean-loup Gailly and Mark Adler (

GH Software is a trademark used by GHIT ApS
Windows® is a registered trademark of Microsoft© Corporation
Other trademarks, trade names and service marks belong to their respective companies.

Click here to read the entire privacy, distribution, liability and copyright statement


DomainScan Server monitoring can monitor any WMI or SNMP enabled device. However the host server must meet certain minimum requirements:

Hardware requirements
(For the DomainScan host system)
Processor32-bit Pentium MMX class or better (x86). 64-bit (x64 class) processor
MemoryAs required by the host system
Disk space50 MB for installation files + additional space for database and log files
NetworkIPv4 or IPv6 compatible

Software requirements
For the DomainScan Client and DomainScan Server Monitoring Service host system

Operating SystemWindows 2000 to Windows 10 / Windows Server 2016
Excluding Windows RT, Home and Starter editions, as well as embedded editions.

It is essential for DomainScan that the Computer Browser service in Windows is running, which may not be the case, if Windows Firewall (or any other firewall solution) is present. See Techdoc 5 for details.

DomainScan Server Monitoring Service must run with administrator privileges to utilize all tools. On Windows Vista or newer, administrator privileges are required for both Client and Service

See technote 8, technote 9 and technote 10 for details about security and notes about the various editions of Windows


Clean installation
1: Run the setup file. Install DomainScan (Service + Client) on one server.
2: Start DomainScan and follow the Setup Wizard that will guide you though the initial setup.
3: (Optional) Once the initial scan is complete, install DomainScan Client on computers from where you wish to be able to work with DomainScan.

1. Stop DomainScan Service. This can be done from within DomainScan in Settings.
2. Close DomainScan Client.
3. Run the setup file. Install DomainScan Service on one PC, and DomainScan Client on the PC's from where you want to monitor the service.
4. Start DomainScan Service again (either restart the server, or use the Service Setup panel in Preferences)

Note: Skip step 1 and 4 on computers where only DomainScan Client is installed.

1. Important Stop and then uninstall DomainScan Service. This can be done from within DomainScan in Settings.
2. Close DomainScan Client.
3: Run the uninstall program.




Sep 7, 2015


Download archive  |   Version history   

Download sites